For all those intrepid launch edition Trimal S1 owners, here are some tips and identified issues from the community. Making this the best Aussie grill out there is a community effort so your feedback is valuable.
If you find any issues, or have suggestions please flick through a photo or two.
Assembly
Cabinet Doors Won’t Fit In
Problem
Cabinet doors can not fit in. This is due to the bottom panel sitting a little high.
Solution
Using the side of your fist or rubber hammer strike direction in the corner where the door pin goes. This should drop the panel down the tiny amount required for the door to fit in. If this still doesn’t work, loosen off the screws, fit the door and tighten back up. See the video below.
Lid Rubbing When Closing
Problem
Grill lid slightly out of alignment causing side to rub.
Solution
Looses of the lid screws, align lid properly in position that doesn’t rub and tighten back up. See video below.
Accessories
Front & Side Bench Screws
Do not use the black screws that are pre-installed on the bottom of the grill. These are used to plug the holes if the benches are not used. Instead, use the flush mounting stainless steel screws supplied with the benches.